|
|
|
|
 |
Steps to get started
Refilling the water reservoir during use
Attaching and Removing Accessories
Safety Instructions
Steps to getting started Step 1 Turn the switch on the hose in the OFF position. Step 2 Push the switches on the machine with no light down. (the light will go off) Step 3 Unplug the electrical cord. Step 4 Make sure the machine is cool (no pressure build up). Step 5 Open the door for the filler cap.
Press down the filler cap and turn counter clockwise until the filler cap is totally removed.Step 6 Place filler funnel in the opening from the water tank and fill the tank with tap water. Step 7 Replace filler funnel and replace the filler cap turning clockwise and pressing down until the filler cap is firmly tight. (Do not over tighten cap). Step 8 Plug electrical cord into 110/120 volt outlet with grounding.
(Unit must be grounded)Step 9 Push the heating and steam switches on the unit down. Step 10 The heating/steam indicator lights on the switches will go on (Yellow) Step 11 After the unit is heated up, the vapor indicator light will light up (Green) During operation the VAPOR indicator light will go on and off. This means the unit is heating during use.
Refilling the water reservoir during use
- The low water light will go on when the unit must be refilled (Yellow).
- Unplug the electrical cord from the outlet.
- Turn all ON/OFF switches in the OFF position.
- Never open the filler cap when unit is hot. Make sure the unit has cooled down.
- Open the filler cap with PRECAUTION slowly.
- When refilling the unit with water, see Steps to Get Started 1-11 above.
Attaching and Removing Accessories
Extensions:
- To connect the extensions: press firmly on the button and slide the connecting extension in until the button is firmly engaged. Make sure that the extensions are firmly pushed together and the button is firmly engaged.
- To remove the extensions: press the button down and slide the extension forward until the extension has been removed.
Large Area Brush:
- To connect: press firmly on the button from the extension of hose handle and slide the large area brush until the button is firmly engaged.
- To remove: press the button down and slide the large area brush until the large area brush has been removed.
Detail Brush Attachment:
- To connect: press firmly on the button from the extension or hose handle and slide the brush attachment until the button is firmly engaged.
- To remove: press the button down and slide the brush attachment until the brush attachment has been removed.
Grout Detail & Medium Detail Brushes:
(Use a cloth or kettle holder to handle for protection)
- To connect: push the detail brush firmly on the nozzle from the detail brush attachment. Make sure the detail brush is very tight.
Safety Instructions
- Unplug electrical cord from outlet when servicing, refilling water or when unit is not in use.
- Turn off all control switches before unplugging.
- Use caution when using the unit around a bath tub, shower, pool, stairs, etc. If the unit falls into water or is set in water, pull the electrical cord immediately from the outlet.
- Never use any chemical or substances other than water in the unit. The use of other substances will VOID the warranty.
- Do not used this unit as a toy.
- Do not let children use or play with this unit.
- Use extra care when using the unit near children.
- Use only the recommended attachments.
- Use this unit for nothing else but for cleaning.
- Do not use this unit for cleaning animals.
- Do not point the vapor at humans or animals.
- Keep all body parts away from the vapor output.
- Do not pull or carry the unit by the electrical cord.
- Do not close a door on the electrical cord.
- Do not pull electrical cord around sharp corners or edges.
- Do not run unit over the electrical cord.
- Do not let electrical cord touch heated surface.
- Do not unplug by pulling on the electrical cord.
- Do not touch plug or unit with wet hands.
- Do not put any object into openings.
- Do not let water run over the unit.
- Do not leave unit outside overnight.
- Do not drop unit.
- Do not use the unit with damaged electrical cord, or body.
- Keep openings free of dust, hair, and anything that may reduce the flow of vapor.
- After using the unit, store in a dry and safe place.
We now offer the MicroFiber Majic Cloth™ as an excellent companion product for use with your Steam
Vapor Cleaning system. Click here or on the Cloths to learn more about this great product.
This amazing product is sold in 2 different Pack sizes -
Pack of 12 Cloths - (each Cloth is 16"x16") - $25.00 + $6 for UPS Ground shipping and applicable Florida Sales Tax (this delivery option available only in the Continental US)
Pack of 4 Cloths - (1 - 16"x16", 2 - 12"x12", 1 - 6"x6" Cloths) - $9.95 + $6 for UPS Ground shipping and applicable Florida Sales Tax (this delivery option available only in the Continental US)
Click here for MicroFiber Majic Cloth ordering information
Email: sales@steamvaporclean.com
